Strike Industries Ambush 45 Degree Optic Mount

The Strike Ambush 45-Degree Optic Mount gives you a modular dual mounting plate design which covers just about all mainstream red dots on the market. When you want to run a dual optic setup and have a close distance Mini/Micro Red Dot Sight (MRDS) with a Low Power Variable Optic (LPVO) scope, this 45-degree optic mount is a low-profile and high-strength accessory without forcing you to pick only one red dot you have to pair it up with. The 45-degree angle should get you out of the way of most LPVO scopes along with two mounting positions to pick from on the SI Multi-Optic Mount side. Easily place a MRDS alongside a LPVO with the low-profile SI-Ambush Picatinny rail mount that either sits flush with the top of the Pic rail or slightly below making it easier to sit under a scope or scope mount. The Strike Ambush 45 comes with a dual footprint mounting plate which has the SI Multi-Optic Mount on one side and the Aimpoint® Micro Standard footprint for T-1/T-2 compatible red dots on the other side making this a new innovative modular option for a diverse market. The SUS630 hardened stainless steel Picatinny rail mount is ambidextrous for either side. The 6061-T6 aluminum mounting plate can be flipped to select which MRDS but also oriented to work with the right or left side of the Pic rail. Fitment for one or fitment for almost all MRDS’ on the market, the Strike Ambush 45-Degree Optic Mount gives you a simple, compact and modular just about all-in-one solution.

MOUNT COMPATIBILITY: 1913 Picatinny

(See individually listed red dot compatibility and suggested hardware to use in PRODUCT SPEC tab)
RED DOT COMPATIBILITY:
-Aimpoint Micro Standard
-C-MORE, DELTAPOINT PRO, DOCTER/NOBLEX, RMR STANDARD, SHIELD STANDARD & all SIG SAUER Open Reflex Sights

WARNING:
-When using screws provided in the package, there is always a chance of hardware marring your optic housing finish/coating
-Be careful and use your best judgment on which hardware to use for your specific setup
-All installations should only be done by a certified professional gunsmith and properly tested to pass all safe and function tests

Torque: Do not exceed 15 in/lbs (1.69 nM) for the Picatinny mount screw